Laser Diode Testing

          Naso High Power Laser Diode Modular Test Station is designed to test 48 laser diodes. The laser diodes are placed on a cooling manifold then pneumatically clamped. The cooling manifold can accommodate six laser diodes. There are a total of 8 manifolds in the test station. The LD current driver is capable of controlling and sourcing four channels for a total of 24 diodes (2 current drivers per station).

NASO Corporation 30 years in the electronics and mechanical contract manufacturing industry. NASO has been the primary manufacturer of NEWPORT laser diode burn in systems for six years. NASO has acquired the NEWPORT burn in systems division. NASO is servicing, repairing, and supporting all existing systems (more than 1000 systems operating world wide). NASO is providing hardware and software upgrades for legacy systems. NASO is providing upgraded versions of the NEWPORT high power systems. NASO has developed a high power burn in systems providing in excess of 100 amps. High Power Laser Burn In System Supports up to 8 CCP or FAP manifolds for 48 channels total Supports up to 4 WCP manifolds with chillers mounted in base Modular design can be set up for a single manifold or a full set of eight Data acquisition capable of full instrumentation or simple burn 48 Channel Laser Burn In System Universal High Power Test Rack Eight drawer manifold capacity Dual laser drivers up to 160 amp, 60 volt compliance Control computer Safety Interlock System Data acquisition system Pnumatic System Cooling and flow control circuit CCP and FAP manifolds are available WCP manifolds are supported with optional chiller Laser Driver Shut Down with Fault Detected Emergency manual shut down switch Water leak monitor in each manifold Laser clamp open fault Air pressure monitor Flow rate monitor Laser tempurature monitor Software over ride